Ford Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
1987 2.3l na mods:
Bored .030
Crower 5.2 rods, arp rod bolts, icon forged floating pistons, had crankshaft turned, head ported and polished and had comb chamber closed up, new valve job, lunati .460 .460 cam, ranger header, msd Street fire coil, 500 CFM 2 barrel, durasprk 2 ignition box, distiributor from a 1982 2.3l Ford, hiflow oil pump, tapped block got mechanical fuel pump.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #2
Put motor in the motor will turn over but when I put a screw driver into the plug wire that hits the coil and move it near the coil I'm getting no spark. What do you think it could be? Still have a jumbled up mess of wires from the efi setup slowly trying to get rid of what's not needed also.
 

·
Registered
Joined
·
1,526 Posts
Make sure your ignition box power source is hot with the key in "run" and "cranking" position.
 
1 - 4 of 4 Posts
Top