Ford Mustang Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
60 Posts
Discussion Starter #1
Have a set of 1-3/4 long tubes and 2-1/2 dr gas xpipe sitting in my garage...the 408w I have has been built well with a .672 solid roller and will be paired with a T-trim vortech...I’m thinking the exhaust I have is too small and was thinking about 1-7/8 kooks headers and a 3 inch xpipe and exhaust...anybody have a similar setup or thoughts...?

thanks
paul
 

·
Registered
Joined
·
976 Posts
I would go with 1 7/8 headers and 3' if possible. I have 1 3/4 and 3" exhaust on my Dart based 353 (3.25 x 4.155) and wish I had 1 7/8.
 

·
Registered
Joined
·
60 Posts
Discussion Starter #8
327blwn...thanks for the info..Is this the same build I see in your signature with the T-trim...? what numbers are u getting...I want the most out of my 408w with the .672 cam....I think the 1-7/8 With a 3 inch xpipe should be good, just trying to figure out mufflers or race bullets..I have 1-3/4 off my old build with the 351 And figure they’re a little smalll
 
1 - 8 of 8 Posts
Top